• The parts needed for mounting the laser head on the X-Y CNC are shown below:

Mounting Parts for Laser at Acro-System

  • The following are reccomended for the assembly:
  • Hex keys: 2mm, 3mm
  • Double-sided tape
  • Standard terminal adapter
  • First, rest the laser head such that the 4x M3 x 6mm mounting holes are facing up.
  • Position the black anodized Aluminium mounting plate over the laser head such that the mounting holes are aligned, as shown in the photos below.:

  • Then, attach the mounting plate to the laser head using 4x M3 screws (the smaller ones) with the washers.

Laser Mounting to Acro-Systems Laser Mounting to Acro-Systems

             

  • Insert the 4 larger screws through the outer holes of the mounting plate, and then insert the plastic spacers on them from the other side, as shown in the photos below:

Laser Mounting to Acro-Systems Laser Mounting to Acro-Systems

  • Position the subassembly on the CNC carraige. Align the threaded plates from the other side, which act as nuts, against which to fasten the screws.

Laser Mounting to Acro-Systems  Laser Mounting to Acro-Systems